Yamaha CRUX REV YD110-1 2016 Owner's Manual page 67

2
1
ZAUE2624
1. Axle nut
2. Washer
6. Pull the wheel axle out, and then
remove the wheel.
To install the front wheel
1. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
Periodic maintenance and adjustment
2
ZAUE2625
1. Slot
2. Retainer
2. Insert the wheel axle from the right
side of the vehicle, and then install
the washer and the wheel axle nut.
3. Take the motorcycle off the cen-
terstand so that the front wheel is
on the ground, and then put the
sidestand down.
4. Tighten the wheel axle nut to the
specified torque.
Tightening torque:
Wheel axle nut:
46 N·m (4.6 kgf·m, 33 lb·ft)
7-34
TIP
When tightening the axle nut, hold the
wheel axle with a wrench to keep it
from turning.
5. Install the brake cable to the brake
1
shoe plate, and then connect the
cable to the brake camshaft lever
by installing the brake lever free
play adjusting nut.
6. Adjust the brake lever free play.
(See page 7-19.)
7. While applying the front brake,
push down hard on the handle-
bars several times to check if the
front fork compresses and re-
bounds smoothly.
8. Connect the speedometer cable
by attaching the lock to its original
position, and then place the rub-
ber cover back into original posi-
tion.
7