Powering Off The M320 Router - Juniper M320 Hardware Manual

Powering Off the M320 Router

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
To power off a M320 Router:
On the external management device connected to the Routing Engine, issue the
1.
request system halt both-routing-engines
shuts down both Routing Engines cleanly, so their state information is preserved. (If
the router contains only one Routing Engine, issue the
user@host> request system halt both-routing-engines
For more information about these commands, see the Junos OS System Basics and
Services Command Reference.
Wait until a message appears on the console confirming that the operating system
2.
has halted.
Halt the system ? [yes,no] (no) yes
*** FINAL System shutdown message from root@section2 ***
System going down IMMEDIATELY
Terminated
...
syncing disks... 11 8 done
The operating system has halted.
Please press any key to reboot.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Switch the circuit breaker on each DC power supply faceplate to the off position (
4.
Switch the power switch on each AC power supply faceplate to the off position (
Preventing Electrostatic Discharge Damage to an M320 Router on page 214
Site Electrical Wiring Guidelines for M Series, MX Series, and T Series Routers on page 249
Chapter 9: Providing Power to the M320 Router
operational mode command. The command
request system halt
command.)
).
O
).
O
101