Figure 37: Removing The Rear Fan Tray - Juniper M320 Hardware Manual

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
To remove the rear fan tray (see Figure 37 on page 75):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Loosen the captive screws on the top and bottom of the fan tray faceplate, using a
2.
Phillips (+) screwdriver, number 2.
Grasp the handle and pull the fan tray halfway out of the chassis.
3.
When the fans stop spinning, place one hand under the fan tray to support it, and pull
4.
the fan tray completely out of the chassis.

Figure 37: Removing the Rear Fan Tray

Chapter 7: Installing the M320 Router Without a Mechanical Lift
75