Samsung AC009BNLDCH Service Manual page 203

The procedure of setting option (Cont.)
19 Set the SEG23 and SEG24 values:
a Set the SEG23 value by rotating the Wheel counterclockwise until
the value you want to set appears on the remote control display.
b Set the SEG24 value by rotating the Wheel clockwise until
the value you want to set appears on the remote control display.
When you rotate the Wheel, values appear in the following order:
Step 3
Check whether the option values that you have set are correct by pressing the
[ SEG2, SEG3 ]
[ SEG14, SEG15 ]
Step 4
Save the option values into the indoor unit:
Point the remote control to the remote control sensor onthe indoor unit and then press the
control twice. Make sure that this command is received by the indoor unit.
When it is successfullyreceived, you can hear a short sound from the indoor unit. If the command is not received,
press the (Power) button again.
Step 5
Check whether the air conditioner operates in accordance with the option values you have set:
a Reset the indoor or outdoor unit.
• Indoor unit : Press the
• Outdoor unit : Press the K3 button.
b Remove the batteries from the remote control,insert them again, and then press the
remote control.
Samsung Electronics
Steps
[ SEG4, SEG5 ] [ SEG6, SEG8 ]
[ SEG16, SEG17 ] [ SEG18, SEG20 ]
(Set) and
[ SEG9, SEG10 ]
[ SEG21, SEG22 ]
(Option)buttons on the remote control simultaneously for 4 seconds.
Troubleshooting
Remote control display
SEG 23
SEG 24
(Mode) button repeatedly
[ SEG11, SEG12 ]
[ SEG23, SEG24 ]
(Power) button onthe remote
(Power) button on the
4-9