Instructions For Maintenance; Replace Basic Device - Siemens SIPROCESS GA700 Operating Instructions Manual

Maintenance and service

10.2 Instructions for maintenance

10.2 Instructions for maintenance
Cleaning the device
Impurities on the device exterior can be removed with a moist cloth and solvent-free
commercial detergent.
Note
Only apply light pressure when cleaning the surface of the display. Water must not enter the
interior of the device.
The device interior can be cleaned carefully with a compressed air gun.
10.3

Replace basic device

The basic device is completely parameterized, the serial number and factory data are saved.
1. Fit the previously used analyzer module (AM) into the new basic device.
2. Enter the user-specific parameters of the basic device again or, if they have been saved
See also
OXYMAT 7 (Page 28)
58
– Subsequent to switching on the device, the AM is recognized as new.
– Each AM retains its parameter settings.
on a PC using Simatic PDM, download these to the device.
Operating Instructions, 01/2013, A5E31874006-01
Rack-mounted device