Table of Contents
Advertisement
12
BASIC OPERATION INSTRUCTIONS
Power Elevating Leg Rests
The high-pivot power elevating leg rests use a high pivot
point to more closely mimic the motion of the knee during
leg rest elevation. They can be adjusted either as a pair or
individually. See figure 12. The high-pivot power elevating
leg rests provide 70° of movement, have standard calf pads,
accept all foot plates, and have a maximum weight capacity
of 300 lbs. (136 kg). They are available with all power bases
that support upgraded electronics and with the Synergy
Seating System. The high-pivot power elevating leg rests
operate through the power chair controller or toggle switch.
NOTE: Operation instructions using the joystick 4-way
toggles are discussed below. If you are using a different
toggle, the Attendant Control Module, or a different
operating device, please refer to the operation manual
supplied with that device and/or your power chair
owner's manual.
To operate the combined leg rests:
1. Push the toggle switch to the right to elevate both leg
rests.
2. Push the toggle switch to the right, release, then push to
the right again to lower both leg rests.
NOTE: For information on operating individual power
elevating leg rests, please refer to the operation manual
that refers to the operating device you are using, or
contact your Pride/Quantum Rehab Provider.
Figure 12. Power Elevating Leg Rests
Advertisement
Table of Contents
