Wolf RM-2 Installation And Operating Instructions Manual page 41

Appendix
10.1.1 Restart RM-2
Initialising the heating/ventilation system. The RM-2 will establish
w
the eBus connection and look for WOLF components in the
system. A moving rectangle will be displayed along with the
current FW version while it is searching.
General fault message page and controller fault message page.
8)
Appears if no compatible WOLF system is detected when the unit
is turned on for the first time. It will also appear if the connected
heating or ventilation unit was not detected when using the unit as
a controller.
Fault message page - remote control. The RM-2 stores the
8!
heating/mixer circuit that was connected on initial startup. This
fault message will be displayed along with the number of the
given circuit if this circuit is no longer in the eBUS system.
3066510_202108 WOLF GmbH | 41