Malfunctions - Porsche Mobile Charger Connect Driver Manual

Malfunctions

Fig. 43 Display of malfunctions
Situation
The display (screen, status LEDs, Power button) has stopped working com-
pletely.
The display is blank, the status LEDs do not change colour and the Power button
lights up red.
Restricted operation or charging not possible (message on display).
80
Status LEDs light up red
A
Error message and cause
B
Remedy
C
In the event of faults or malfunctions, the charger
shows a corresponding message on the display. The
status LEDs and the Power button light up red.
The message shows details of the error, information
about the cause and a remedial measure.
e
Follow the instructions provided for the remedial
measure.
NOTICE
Damage to the charger
Recommended action
e
Disconnect the charger from the mains supply and have it replaced.
e
Have the domestic installation checked by a qualified electrician.
e
The charger is overheated. Disconnect the charger from the mains supply
and allow it to cool down slowly on its own.
e
If the error persists, have the charger replaced.
e
Make sure that the supply cable and vehicle cable are connected to the con-
trol unit at the correct side and are plugged into the connections correctly.
e
Make sure that the charger is within the permitted temperature range.
g Refer to chapter "Technical Data" on page 85.
e
Acknowledge any error message that appears.
e
Restart the charger. Press the Power button for at least 10 seconds to
restart.
e
If a fault persists or recurs, disconnect the
charger from the mains supply and contact a
qualified electrician. Porsche recommends that
you use a certified Porsche service partner.
The following overview contains recommendations
for dealing with malfunctions that restrict or prevent
charging of the vehicle.