Selecting The Installation Location - Porsche Mobile Charger Connect Driver Manual

Selecting the installation lo-
cation
Electric shock, fire
DANGER
Improper use of the charger or non-compliance with
the safety instructions may result in short circuits,
electric shocks, explosions, fire or burns.
e
Do not install the basic wall mount or the charg-
ing dock in potentially explosive areas.
e
Before installing the basic wall mount or the
charging dock, make sure that there are no elec-
tric cables in the vicinity of the mounting holes
to be drilled.
e
To reduce the risk of explosion - particularly in
garages - make sure that the control unit is
located at least 50 cm above the floor during
charging.
e
Observe the locally applicable electrical installa-
tion regulations, fire protection measures, acci-
dent prevention regulations and escape routes.
The basic wall mount and charging dock are designed
for indoor and outdoor installation. The following cri-
teria must be considered when selecting a suitable
installation location:
–
Ideally, install the electrical socket and supply
line, the basic wall mount or charging dock in a
covered area that offers protection from direct
sunlight and rain (e.g. in a garage).
– The distance of the electrical socket from the
floor and ceiling should be selected in compli-
ance with national regulations and standards so
that comfortable use is ensured.
–
Do not install the basic wall mount or charging
dock under suspended or hanging objects.
58
–
Do not install the basic wall mount or charging
dock in stables, livestock buildings or places
where ammonia gases occur.
–
Install the basic wall mount or charging dock on
a smooth surface.
– In order to ensure secure fastening, check the
condition of the wall before installing.
– Install the basic wall mount or charging dock as
close as possible to the preferred parking posi-
tion of the vehicle. Take the orientation of the
vehicle into account.
–
Install the basic wall mount or charging dock
so that it is not near pathways and the supply
cables do not cross any pathways.
–
Install the basic wall mount or charging dock so
that the distance between the power plug and
power socket does not exceed the length of the
available supply cable.