Table of Contents
Advertisement
4.3
Assembly procedure
Specific safety measures
Risk of electric shock when moist due to condensed water
Before commissioning the charging station, an authorized and qualified electrician must
check whether there is moisture in the charging station. Remove even small amounts of
condensed water before commissioning. Take appropriate measures for drying.
Do not switch off the power supply for an extended period of time after commissioning.
This will prevent condensation in the charging station. If the charging station is to be
switched off for a longer period of time, you need to provide suitable moisture protection.
Crushing hazard
The weight of the standard version is 75 kg. Depending on the options ordered, the weight
differs from the standard version. Lifting the unit may result in hazards that could cause not
only serious material damage but also serious injury.
• Only lift the system with at least two persons and suitable lifting equipment.
• Follow accident prevention regulations.
• When setting down the load, make sure that no body parts are trapped.
Do not insert or hook fingers into eyelets, cable grommets, or openings.
Risk of accident
Using a crane or other mechanical lifting gear may result in hazardous situations that could
cause death or severe injury.
• Do not operate cranes or other mechanical lifting equipment when not instructed to do
• Do not leave elevated loads unattended.
• People must not stay underneath loads, or between loads and obstacles.
Follow safety instructions for the crane or lifting gear.
Risk of accident
Risk of accident when the charging station is not secured.
• Do not leave the charging station unattended.
• Place or lay down the charging station and its parts in such a way that the charging
SICHARGE Operating instructions, ERK
Operating Instructions, 06/2021, A5E48571690-AC
DANGER
WARNING
WARNING
so.
WARNING
station and its parts cannot tip over or fall down.
Assembly/installation
4.3 Assembly procedure
35
Advertisement
Table of Contents
