Wolf SO24 E Series Service Manual page 44

Back Component Removal and Installation
Install the Exhaust Tube
1 Insert the exhaust tube into the oven cavity.
2 Use a T-20 Torx bit to install the screws into the exhaust
tube bracket.
3 Place the temperature sensor mount onto the exhaust tube.
4 Use a T-10 Torx bit to tighten the screw in the temperature
sensor mount.
EXHAUST TEMPERATURE SENSOR REMOVAL
WARNING
Turn off the power to the product before starting this
procedure.
To remove the exhaust temperature sensor, first
unit
, then remove:
1 Top cover
Back cover
2
Remove the Exhaust Temperature Sensor
1 Use a T-10 Torx bit to loosen the screw on the temperature
sensor mount.
TIP: Make a note of the position of the exhaust sensor
mount.
2 Remove the temperature sensor mount from the exhaust
tube.
3 Use a T-10 Torx bit to remove the screw from the exhaust
temperature sensor.
4 Disconnect the wire harness of the exhaust temperature
sensor from X12 on the relay board.
5 Remove the exhaust temperature sensor from the unit.
Temperature
Sensor Mount
(Back of Oven)
Exhaust Tube
(Oven Interior)
827705 REVA 01/2019
uninstall the
Exhaust
Temperature
Sensor
43
E Series SO24 (SWS 13543126)
EXHAUST TEMPERATURE SENSOR INSTALLATION
After installing the exhaust temperature sensor, install:
1 Back cover
Top cover
2
install the unit
Then .
Install the Exhaust Temperature Sensor
1 Place the exhaust temperature sensor into the unit.
2 Connect the wire harness of the exhaust temperature
sensor to X12 on the relay board.
3 Use a T-10 Torx bit to install the screw into the exhaust
temperature sensor.
4 Place the temperature sensor mount onto the exhaust tube.
5 Use a T-10 Torx bit to tighten the screw on the temperature
sensor mount.
PYROLYSIS DUCT COVER REMOVAL
To remove the pyrolysis duct cover, first
Remove the Pyrolysis Duct Cover
1 Use a T-20 Torx bit to remove the screw from the pyrolysis
duct cover.
2 Remove the pyrolysis duct cover from the unit.
PYROLYSIS DUCT COVER INSTALLATION
After installing the pyrolysis duct cover,
service.subzero.com
uninstall the unit
.
install the unit
.