Display Removal; Control Board Installation - Wolf SO24 E Series Service Manual

Top Component Removal and Installation
Remove the Control Board
1 Open the lock(s) on the ribbon cable connectors, and
remove the ribbon cable(s) from the control board.
2 Disconnect the wire connectors from the control board.
3 Open the tabs on the control board bracket along the top of
the control board.
4 Remove the control board from the control panel.

CONTROL BOARD INSTALLATION

After installing the control board, install:
1 Panel assembly
Then install the unit .
827705 REVA 01/2019
E Series SO24 (SWS 13543126)
Install the Control Board
1 Insert the ribbon cable into the ribbon cable connector and
lock the ribbon cable connector.
2 Connect the wire connectors to the control board.
3 Place the bottom of the control board into the control board
bracket supports.
4 Push the top of the control board into the control board
bracket.

DISPLAY REMOVAL

WARNING
Turn off the power to the product before starting this
procedure.
To remove the display, first
Panel assembly
1
Control board
2
Remove the Display
1 Lift the tabs on the control board bracket at the top of the
display.
32
service.subzero.com
uninstall the unit
, then remove: