Mount And Set The Ignition Coil - KTM S5-E Repair Manual

1
A
1
0,25 ÷ 0,35 mm
2
– Insert the woodruff key into the crankshaft and slide the flywheel onto the
crankshaft.
– Mount washer and hexagon nut.
– Hold the flywheel with the holding wrench and tighten the hexagon nut with
30 Nm (22 ft.lb.).

5.6 Mount and set the ignition coil

– Mount the ignition coil with 2 screws
still be possible to move the ignition coil sideways.
– Measure the distance between flywheel and ignition coil at points
ler gauge and adjust the distance.
A
DMISSIBLE DISTANCE
1
– Tighten screws and check distance again.
2
– Insert the rubber into the opening of the housing and fasten the ignition cover
with the two retaining springs.
1
. After tightening the screws it should
: 0.25 - 0.35 (0.01 - 0.015
MM IN
A
with a fee-
.)
15