To Review The Set Temperature; Commercial Programmable Mode; On /Off And Mode Selection; Setting The Fan Functions - Robertshaw SENSE SMART 2000 Owner's Manual

If desired, while the program is held, the current set temperature can be adjusted
by pressing and holding the p or  buttons for three seconds. The thermostat
display will change to show the word SET, and the active setpoint for the current
mode (Heating or Cooling). As you hold the p or  buttons, the current setpoint
will change.

To Review the Set Temperature

Press the p or  buttons to first turn the LCD backlight ON, then press again to
display the currently set temperature(s).

COMMERCIAL PROGRAMMAbLE MODE

On /Off and Mode Selection

Press the Mode button to cycle the thermostat through the available modes,
Heat, Cool, Auto mode (Shown by HEAT and COOL in the LCD), Emergency Heat (if
fitted), and OFF. If the Fan mode is set to FAN ON, when you select OFF mode the
Fan mode will automatically change to FAN AUTO.
NOTE:
Not all modes may be active on your thermostat.

Setting the Fan Functions

Detail on the fan control functions of the SMART 2000 can be found on page 15
of this manual.
30