Brother P-touch QL-700 Service Manual page 46

(4) Set the two head springs L on the bosses of the back side of the head ASSY, and
assemble the head ASSY onto the mecha ASSY as shown in the figure.
NOTE 1: Confirm that the head ASSY moves smoothly.
NOTE 2: Confirm that the head springs L are properly inserted into the upper and
Head ASSY
4b
Head springs L
Mecha ASSY
4c
Hook the left and right arms of the head ASSY on the release shaft.
Release shaft
CAUTION: Pay attention not to give strong impact on the heating element of a
lower bosses.
Bosses
4a
4b
4c
Release shaft
head ASSY when mounting the head ASSY.
Head ASSY
Heating element
Fig. 3.5-4 Reassembling the Mecha ASSY (4)
Insert the head springs L properly
into the bosses of the mecha ASSY.
4d
III - 28
Insert the head springs L properly
into the bosses of the head ASSY.
4e
4d