Table of Contents
Advertisement
Using the HDD display
You can check information about the HDD
using the display while recording.
To display time information while
recording
Press TIME repeatedly.
Each time you press the button, the display
changes as follows:
Track number and elapsed time of the
current track t Percentage of the HDD area
used as the total recorded time
Notes
• The total recorded time is first displayed as a
percentage. When the remaining recordable time
reaches "999. 59" (999 minutes and 59 seconds),
the display changes to a time display.
• The percentage of the HDD area used will never be
0% even when no tracks have been recorded to the
HDD.
Tip
"Analog In" appears in the display when you record
through the ANALOG IN jack, and "Optical In"
appears when you record through the DIGITAL
OPTICAL IN connector.
Recording to the HDD
1
Turn on the amplifier and set the
source selector to the position for this
recorder.
2
Press @/1 to turn on the recorder.
3
Press the respective button on the
remote to select the sound source.
Sound source
The CD in the recorder
The component connected
to the DIGITAL
OPTICAL IN connector
The component connected
to the ANALOG IN jacks
4
Press z.
"REC" appears in the display.
The HDD stands by for recording.
To change the album position, press
ALBUM +/– (or turn the ALBUM dial on
the recorder) repeatedly. To enter the
position directly, press ALBUM and the
numeric button(s) (see page 19).
When recording through the ANALOG IN
jack, adjust the recording level (see
"Adjusting the recording level" on page 17)
if necessary.
5
Press H (or the PLAY/NEXT/PREV dial
(H) on the recorder) or X.
Recording starts.
6
Start playing the sound source.
Other operations during recording
To
Stop recording
Pause recording
Resume recording after
recording pause*
Add a track number
* Track number increases by one.
Press
CD
OPTICAL
ANALOG
Press
x
X
X or H (or the PLAY/
NEXT/PREV dial (H)
on the recorder)
z
continued
13
Advertisement
Table of Contents
