Display - Sony PCM-7040 Operation Manual

2-2 Display

While the unit is on, the display shows information
relevant to the current state of the unit. Refer to this
section as required.
Basic display
When you turn on the unit, the display will show
initializing information for several seconds.
1 2
TIME CODE
SMPTE
CH-1
CH-2
1 Level meters
Indicate the audio signal levels.
2 Tape time display area
Shows the tape time or error messages. When the tape
time is displayed, type of tape time (time code,
absolute time, or counter time) is also indicated.
3 DISPLAY key menu display area
Shows the DISPLAY key menu selection. The initial
selection is "LOCATE POINT". To change the
selection, use the DISPLAY select key.
4 Input/set data display area
Shows the data corresponding to the current DISPLAY
key menu selection.
5 Chase mode indicator
Shows the chase mode setting. The unit has been
factory set to RE-CHASE ON (this indicator lights).
2-6
Chapter 2 Location and Function of Parts and Controls
H H H
- -60 -50 -42 -34 -28 -22 -18
Upon initialization, the basic display showing the
factory settings will appear.
The following explains the basic display.
3
LOCATE POINT
DF dB
H HF MB
-14 -10 -8 -6 -4 -2 0 OVER
6 Sampling frequency indicator
Shows the sampling frequency (44.1 kHz or 48 kHz).
Figures and alphabet shown in the display
Figures and characters (alphabet) appear as shown
below in the tape time display area and input/set data
display area.
Figure 1 2 3 4 5 6 7 8 9 0
Indication
Alphabet A B C D E F G H I J K * L M * N
Indication
Figure O P Q R S T U V * W * X * Y Z *
Indication
*These characters do not appear.
4
dB
S F%
RE–CHASE
FS 148
5 6