Table of Contents
Advertisement
Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1
installation
....................................................................................................................................................................................................................................
...................................................................................................................................................................................................
Connect one end of the Ethernet cable to the 9962 MSEC v1.0.
2
...................................................................................................................................................................................................
3
Connect the other end of Ethernet cable to the router.
...................................................................................................................................................................................................
Finally, secure the Ethernet cable to the wall.
4
E
N D
O F
...................................................................................................................................................................................................
Connect to the GPS antenna
The GPS antenna is used for synchronization purpose. Perform the following steps to
connect the 9962 MSEC v1.0 to the GPS antenna:
...................................................................................................................................................................................................
Route the GPS antenna cable to the 9962 MSEC v1.0 access point.
1
...................................................................................................................................................................................................
2
Connect the GPS antenna cable to the dedicated SMA connector in the 9962 MSEC v1.0.
...................................................................................................................................................................................................
Finally, secure the GPS antenna cable to the wall.
3
E
N D
O F
...................................................................................................................................................................................................
Daisy chain
The 9962 MSEC v1.0 access point can be linked in a daisy chain. Fiber links are not
allowed in this configuration.
The daisy chain hop is set by connecting the SFP slot of the "Master" access point to the
RJ45 port of the "Slave" access point. Therefore, the "Master" SFP slot must be equipped
with an appropriate RJ45 SFP.
Up to eight 9962 MSEC v1.0 access points can be daisy-chained.
....................................................................................................................................................................................................................................
Alcatel-Lucent 9962 MSEC v1.0
3MN-02001-0002-RJZZA
Issue 2.01 September 2015
S T E P S
S T E P S
Cabling
2-27
Advertisement
Table of Contents
