Alcatel-Lucent 9962 Hardware Installation page 31

Multi-standard enterprise cell
Table of Contents

Advertisement

Alcatel-Lucent 9962 Multi-standard Enterprise Cell v1
installation
....................................................................................................................................................................................................................................
Mount to wall
Falls can occur when working at heights resulting in serious personal injury or death.
To prevent a fall when working at heights (ladder, scaffold, manlift, roof etc.) follow safe
work practices and wear appropriate fall protection equipment.
To mount the device onto a wall, perform the following steps:
...................................................................................................................................................................................................
Connect the RF stick antennas on the 9962 MSEC v1.0 access point.
1
Note: The wall mount implies that the access point is vertically installed with the stick
antennas pointing upwards (not downwards or sideways). The stick antennas cannot
be bent. Failure to comply with these requirements would change and degrade the
omnidirectional radio frequency pattern.
Figure 2-3 9962 MSEC v1.0 stick antennas
....................................................................................................................................................................................................................................
Alcatel-Lucent 9962 MSEC v1.0
3MN-02001-0002-RJZZA
Issue 2.01 September 2015
WARNING
Fall hazard
Mounting guidelines
2-9

Advertisement

Table of Contents
loading

Table of Contents