Cavity Light - GE Advantium 240 Technical Service Manual

https://appliancetechmanuals.com

Cavity Light

The oven lamp is attached to the inside of the cavity
light housing with 2 Phillips-head screws. The light
housing is attached to the oven with 2 Phillips-head
screws. A single wire harness is connected to the
oven lamp. It is necessary to remove the outer cover
to access the oven lamp. (See
.)
Removal
The oven cavity light will only come on when the
door is opened.
Light Housing Interior
Caution
• Do not twist the lamp. The bulb may be glued to
the holder assembly.
• Using gloves or a dry cloth, remove the
replacement bulb from its packaging. Do not
touch the bulb with bare fi ngers. Oil from bare
fi ngers may cause hot spots on the glass
surface and lead to premature failure of the
bulb. If you do touch the glass, clean it with
alcohol prior to installation.
Oven Removal / Partial
Harness
– 30 –
Note
• The oven lamp is a 12 VAC, 20-watt lamp (Part #
WB01X10239).
• To replace the bulb it may be necessary to cut
the glue away from the bulb. The bulb can then
be pulled out of the holder assembly. It is not
necessary to glue the replacement bulb in place.
• The holder assembly
available separately. (Part # WB06X10726).
Light Removed From Housing Interior
Holder Assembly
Glue
(bulb not included) is