GE Profile Advantium PSB2200NBB Dimension Manual

PSB2200N
GE Profile Advantium
Advantium wall oven/GE Profile cooking tower dimensions and cabinet installation information (in inches)
21-1/2"
Note: Cabinets
Excluding
Handle
installed adjacent
to wall ovens must
have an adhesion
spec of at least a
194°F temperature
19-1/32"
rating.
Note: 2" minimum
between cutouts
when installed
above warming
drawer or single

wall oven.

Installation
Information:
Before installing,
consult installation
A=Allow 1" overlap of oven over top and bottom
instructions packed
edges of cutout.
B=Allow 11/16"-3/4" for overlap ov oven over side
with product for current
edges of cutout.
dimensional data.
A=Allow 7/8" overlap of oven over bottom and 1/4" overlap at top
edges of cutout.
B=Allow 2-1/8" for overlap of oven over side edges of cutout.
For answers to your Monogram, GE Profile
®
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center ® service,
800.626.2000.
240 Wall Oven
®
4-3/16
Cutout width
25-1/8"
23-1/2"
Cutout depth
A
B
Conduit
17-1/2"
(48-1/2"
Cutout height
long)
Required
29-25/32"
cutout location
36-3/4"
minimum
from floor
30
or
™
Suitable
bracing
21-5/8"
to support
over centerline
runners
of cabinet
(Must support 130 lbs.)
cooking_tower_solid_floor.eps
Junction
box
location
H
(240-Volt
models only)
Construct Solid
Bottom Min.
3/8" Plywood
Supported by
2 x 4 or 1 x 2
Runners, all
Four Sides.
(Must Support
150 lbs.)
A=Allow 7/8" overlap of oven over bottom and 1/4" overlap at top
edges of cutout.
B=Allow 2-1/8" for overlap of oven over side edges of cutout.
C L
2 x 4's or
equivalent
solid floor
PSB2200/1 without
accessory drawer
PSB2200/1 with
accessory drawer
*For existing cutouts a maximum width of 28-1/2" is acceptable
4-3/16
Cabinet width
A
B
D
Excluding
Handle
W
A
B
Conduit
(46" long)
adv_240_120_cooktower_dia.eps
Cabinet W H Depth
Width Width Height
(excluding
(inches)
30 29-25/32 19-1/8 21-1/2
30 29-25/32 22-1/4 21-3/4
Specification Created 9/08
Junction box location (240-volt models only)
2-1/2" MIN between cutouts
recommended—2" MIN required
Construct Solid Bottom
MIN 3/8" Plywood Supported by
2 x 4 or 1 x 2 Runners, all Four Sides.
(Must Support 150 lbs. for Advantium)
(Must Support 200 lbs. for Wall Oven)
9-1/4" cutout height
28-1/2" cutout width
2" MIN between cutouts
1" Min. above toekick or adjust
to oven installation height
D Z
X Y Cutout
Cutout Cutout Depth
handle) Width Height
(minimum)
25-1/8 17-1/2 23-1/2
25-1/8 to
21 23-1/2
28-1/2*
Listed by
Underwriters
Laboratories
240442