Demo Mode - GE Advantium 240 Technical Service Manual

https://appliancetechmanuals.com

Demo Mode

The sales demo mode will allow dealers to demonstrate all oven functionality with one exception. (See #1
below.)
The sales demo mode can only be entered during the initial
powers up after a long (greater than 60 seconds) power outage.
The sales demo mode will be initiated by holding the
same time for a full 3 seconds.
When sales demo mode is initiated, 2 short-beeps are sounded and all oven functions will operate with the
following exceptions;
1. No power shall ever be applied to the heaters, halogen lamps, magnetron high voltage transformer, or
Inrush control relays. The control relays for any of these loads shall not be switched during sales mode.
However, if you press the
for 4 seconds.
2. The icon will be lit whenever the unit is in sales mode regardless of settings or the feature being
DEMO
selected.
The sales demo mode is cleared by holding the
full 3 seconds. The sales mode can
when the unit powers up after a long (greater than 60 seconds) power outage. After 5 seconds elapse, all
functions of the oven will return to normal operation.
When power-up occurs, software will check the special sales demo identifi er code. If the code is set, then the
oven will stay in the sales demo mode. This will prevent the unit from powering back up to a normal mode if
power to the salesroom had gone off.
S e l e c O C
t C L
0 : 0 0
0
T U R N
POWER / TEMP
D E M O M O D E
4 :
0 0
D E M O
pad while in a demo cook mode, the inner halogen light will come on
DEFROST
POWER / TEMP
be cleared during the same initial
only
– 15 –
display that occurs when the unit
SELECT TIME
M E :
K T I
D I A L
and
START / PAUSE
P M
and pads down at same time for a
START
SELECT TIME
pads down at the
display that occurs