Page 1
For a Spanish version of this manual, visit our Website at ge.com. Para consultar una version en español de este manual de instrucciones, visite nuestro sitiode internet ge.com. 49-40593-1 MFL59060901 12-08 JR Installation Instructions Advantium Built-In SpeedCook Ovens PSB1200 PSB1201...
Product failure due to improper installation is not covered under the warranty. See Owner’s Manual for warranty information. NOTE: This oven is only approved to be installed under the specific models as labeled on this unit. IMPORTANT Use this oven only —...
Weight on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb, sit, stand or hang on the oven door. If installing the drawer accessory, the drawer must be assembled to the oven prior to installation into the cabinet.
ELECTRICAL REQUIREMENTS Single Advantium 120 Installation: This product requires a 120-volt, 60 Hz, 15-amp circuit and draws 1.8 kilowatts. This product must be connected to a supply circuit of the proper voltage and frequency. • Wire size must conform to the requirements of the National Electrical Code or the prevailing local code for this kilowatt rating.
Preparation PREPARE THE OPENING The Advantium 120V can be installed in combination with other GE/Monogram appliances. Always follow each product’s Installation Instructions to complete the installation. Single Advantium 120V Installation: Order a 30″ wide single oven cabinet or cut the opening in a wall to the dimensions shown.
30″ 23-1/2″ 25-1/4″ 17-1/2″ • If you are replacing a GE/Monogram electric double oven with the combined installation of an Advantium 120V and a single oven, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2″...
Page 7
23-1/2″ 30″ 25-1/4″ 17-1/2″ 17-1/2″ • If you are mounting an Under-the-Counter GE/Monogram oven over another, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2″ minimum shown. Installation Preparation WITHOUT an Accessory Storage Drawer PREPARE THE OPENING (cont.)
Page 8
Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for the cutout size. See the label on top of the oven for approved cooktop models. This oven requires a separate, properly grounded 15-Amp, 120-Volt, 60Hz power supply. The cooktop requires a separate power supply. Use a 36″...
Page 9
MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING (cont.) The Advantium 120V can be installed in combination with other GE/Monogram appliances. Always follow each product’s Installation Instructions to complete the installation. Single Advantium 120V Installation: Order a 30″...
Page 10
If the opening is slightly wider, secure a furring strip on each side of the cutout for securing the oven. • If you are replacing a GE/Monogram electric double oven with the combined installation of an Advantium 120V and a single oven, use the dimensions shown.
Page 11
30″ 23-1/2″ 25-1/4″ 21″ 21″* • If you are mounting an Under-the-Counter GE/Monogram oven over another, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 2″ minimum shown. Installation Preparation WITH an Accessory Storage Drawer PREPARE THE OPENING (cont.)
4-1/2″ minimum shown. PREPARE THE OPENING (cont.) Installation under a GE Profile 30″ or 36″ Cooktop or Countertop: Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for the cutout size.
REMOVE THE PACKAGING AND PARTS • Remove all packing material and tape. • Locate parts package containing mounting screws. • Remove the oven from the carton. Do not lift unit by handle or conduit. Two people are required to lift this oven.
DO NOT USE THE HANDLE TO LIFT THE OVEN. DAMAGE WILL OCCUR. • Lift and hold the oven at the front of the opening. Hold the oven at an angle and plug in the power cord.
• Installation Above 36″, align trim tabs on the plastic or metal trim to slots in the bottom of the oven. • Secure the bottom trim to the bottom of the oven using 3 screws provided.
GE Consumer & Industrial Appliances Assembly Instructions Advantium ® Built-In Accessory Storage Drawer JX2200, JX2201, ZX2201 BEFORE YOU BEGIN Read these instructions completely and carefully. Read the Installation Instructions for the Advantium 120V or 240V oven completely and carefully for cutout dimensions and step-by-step instructions.
Page 17
Place the oven on top of the storage drawer. Make sure that the back and sides of the oven align with the back and sides of drawer. NOTE: The bottom of the oven side flanges will sit directly in front of the top of the storage drawer side flanges.
Page 18
ASSEMBLING THE OVEN TO DRAWER (cont.) Remove the front two bottom screws on each side of the oven and the top center screw on each side of the storage drawer. Place the side supports into the tabs on the drawer and secure using the screws supplied and the screws removed in Step C.
Page 20
NOTE: Product improvement is a continuing endeavor at General Electric. Therefore, materials, appearance and specifications are subject to change without notice. GE Consumer & Industrial Appliances General Electric Company Louisville, KY 40225 ge.com...