Setting The Clock; Remote On/Off; Reviewing On/Off Status; Turning System Off - AT&T 992 User Manual

9355_book_1ATT 7/12/99
ANSWERING SYSTEM OPERATION
At Cordless Handset or Touch Tone Phone

Setting the Clock

1 Connect with the answering system.
Press * 8. You will hear the current day, followed by "To change,
2
press 6 or 4. To change the hour, press 8."
Press 4 to move back a day, or 6 to move forward a day.
3
Press 8. The system announces the current hour setting, followed
4
by "To change, press 6 or 4. To change the minutes, press 8."
Press 4 to decrease or 6 to increase hour.
5
6
Follow the same procedure to change the minutes setting.
7 The system announces the new time setting, then beeps twice to
indicate it is ready to accept a command.

Remote ON/OFF

Reviewing ON/OFF Status

1 Connect with the answering system.
Press 0. The system announces the current status, then beeps
2
twice and is ready to accept a command.

Turning System Off

1 Connect with the answering system.
Press * 0. The system announces "The machine is off," then
2
beeps twice to indicate it is ready to accept a command.

Turning System On

When the system is off, it answers after 10 rings, and announces "The
machine is off," then beeps twice to indicate it is ready to accept a
command. Press * 0. The system announces "The machine is on," then
beeps twice.

Recording a Message When System is Off

Press # when the system answers after 10 rings. The system will beep to
signal you to begin speaking.
2:25 PM Page 35
35