Rear Lift Cylinder
11
ROD CLEVIS
1. Hose connection
2. Hose connection
3. Hydraulic fitting
4. Hydraulic fitting
5. O–ring
Removal (Fig. 63)
1. Before removing any parts from the hydraulic man-
ifold, park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
CAUTION
Operate all hydraulic controls to relieve
system pressure and avoid injury from
pressurized hydraulic oil.
Reelmaster 2300–D/2600–D
14
10
15
4
3
5
5
2
1
Figure 63
6. Cap screw
7. Ram pivot pin
8. Pivot support
9. Lift pivot shaft
10. Lift cylinder
Page 4 – 71
13
12
14
9
15
7
8
11. Cotter pin
12. Clevis pin
13. Lift arm
14. Flat washer
15. O–ring
CAUTION
The rear lift cylinder is located near the
muffler exhaust pipe. To avoid possible
burns, allow the exhaust pipe to cool be-
fore working on the rear lift cylinder.
2. Label all connections for reassembly. Disconnect
hose connections (1 and 2) from hydraulic fittings (3 and
4). Allow hoses to drain into a suitable container.
6
Hydraulic System