2Wd/3Wd Two Position Valve - Toro Reelmaster 2300-D Service Manual

2WD/3WD Two Position Valve

13
1. Two position valve
2. Nut
3. Cap screw
4. Tub clamp
5. Hydraulic tube
Removal (Fig. 51)
1. Before removing any parts from the hydraulic man-
ifold, park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
Operate all hydraulic controls to relieve
system pressure and avoid injury from
pressurized hydraulic oil.
2. Clean two position valve (1) and hydraulic fittings.
3. Put caps or plugs on any hydraulic lines or fittings
left open or exposed. Put labels on disconnected hy-
draulic lines and hoses for proper reassembly.
4. Loosen nut (2) and cap screw (3) so the tubes
clamps (4) will allow movement of the hydraulic tubes
(5).
Hydraulic System
1
15
12
13
9
15
11
13
10
8
7
6. Hydraulic connection
7. Hydraulic connection
8. Hydraulic connection
9. Hydraulic connection
10. Hydraulic fitting
CAUTION
14
3
15
5
6
13
Figure 51
5. Disconnect hydraulic connections (6, 7, 8 and 9)
from hydraulic fittings (10, 11, and 12). Allow hydraulic
oil to drain from tubes into a suitable container.
6. Remove cap screws (14) from two position valve
(1).
7. Remove fittings (10, 11, and 12) and O–rings (15)
from two position valve (1).
Installation (Fig. 51)
1. Install hydraulic fittings (10, 11, and 12) and O–rings
(15) into two position valve (1).
2. Secure cap screws (14) to two position valve (1)
through the skirt assembly.
3. Install hydraulic connections (6, 7, 8 and 9) to hy-
draulic fittings (10, 11, and 12) and tighten fittings.
4. Tighten nut (2) and cap screw (3) so the tube clamps
(4) will prevent movement of the hydraulic tubes (5).
Page 4 – 54
2
4
SKIRT ASSEMBLY
5
11. Hydraulic fitting
12. Hydraulic fitting
13. O–ring
14. Cap screw
15. O–ring
Reelmaster 2300–D/2600–D