Adjustments; Transmission For Neutral - Toro Reelmaster 2300-D Service Manual

Adjustments

Transmission for Neutral

If the machine "creeps" when the traction control pedal
is in the neutral position, the neutral return mechanism
must be adjusted.
1. Block up under the frame so one of the front wheels
is off the floor. Place selector control in two wheel drive
position.
2. Start engine, move throttle to SLOW and check front
wheel that is off shop floor; it must not be rotating. Loos-
en pump plate nuts and rotate pump plate until creep
does not occur in either direction. When wheel stops ro-
tating, tighten nuts locking adjustment. Verify the adjust-
ment with throttle in SLOW and FAST position.
3. Should the wheel continue to rotate, check for the
following:
A. Ball bearing is loose or worn out.
B. Loose or missing fasteners.
C. Worn fasteners.
D. Pump lever loose on control shaft.
E. Weak or damaged Ieaf springs. Replace.
F. Internal pump component malfunction.
4. After adjusting the pump plate, check neutral switch
operation and if necessary, adjust as follows:
A. Loosen locknut securing switch adjusting screw.
Thread away from switch until capscrew head
clears switch.
B. Rotate adjusting screw toward switch until circuit
through switch is made. Then, turn adjusting screw
an additional 2–1/2 turns.
C. Tighten locknut
Hydraulic System
2
5
1. Pump plate nut
2. Pump
3. Neutral switch
Page 4 – 34
1
4
3
Figure 19
4. Adjusting screw
5. Lock nut
Reelmaster 2300–D/2600–D