Table of Contents
Advertisement
(8) Large 4-Pin Power Connector：J2 Power Connector
The connectors are 4-pin connector that supports extra 12V / 5V power to your
system
(9) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After
connecting the single plug end to motherboard, connect the two plugs at other
end to your hard disk(s). If you install two hard disks, you must configure the
second drive to Slave mode by setting its jumpers accordingly. Please refer to
the documentation of your hard disk for the jumper settings.
• Two hard disks can be connected to each connector. The first HDD is referred to
as the "Master" and the second HDD is referred to as the "Slave".
• For performance issues, we strongly suggest you don't install a CD-ROM or
DVD-ROM drive on the same IDE channel as a hard disk. Otherwise, the system
performance on this channel may drop.
(10) Serial-ATAIII Port connector:SATA1~SATA6
This connector supports the provided SATA III hard disk cable to connecting the
motherboard with serial ATAIII hard disk.
IDE1
Pin 1
IDE Connector
14
Advertisement
Table of Contents
