Table of Contents
Advertisement
Turn off your power when adding or removing expansion cards or
WARNING!
other system components. Failure to do so may cause severe
damage to both your motherboard and expansion cards.
2-1
Hardware installation Steps
Before using your computer, you had better complete the following steps:
1. Check motherboard jumper setting
2. Install CPU and Fan
3. Install System Memory (DIMM)
4. Install Expansion cards
5. Connect IDE and Front Panel /Back Panel cable
6. Connect ATX Power cable
7. Power-On and Load Standard Default
8. Reboot
9. Install Operating System
10. Install Driver and Utility
2-2
Checking Motherboard's Jumper Setting
(1) KB/USB function Enabled/Disabled: JP1
(2) CMOS RAM Clear (2-pin): JBAT
A battery must be used to retain the motherboard configuration in CMOS RAM
short 1-2 pins of JBAT to clear the CMOS data.
WARNNING：Please remove or turn off the power supply before CMOS clear!
To clear the CMOS, follow the procedure below:
1.
Turn off the system and unplug the AC power
2.
Remove ATX power cable from ATX power connector
3.
Locate JBAT and short pins 1-2 for a few seconds, if shorted with the jump cap,
short for a few seconds then pull out the hat.
4.
Connect ATX power cable back to ATX power connector
Chapter 2
Hardware Installation
JP1
1-2 Closed KB/USB Power ON Disable (Default)
7
JP1
2-3 Closed KB/USB Pow er ON Enabled
KB & USB Power On Setting
Advertisement
Table of Contents
