Advertisement
Installation Notes
Installing the
CAPN
Initialising the
CAPN
Page 5 Enterprise Edge CAPN User Card
The Enterprise Edge Station Auxiliary Power Supply is required to
operate the CAPN module.
You must initialise each CAPN module individually during the first ten
seconds after powering up to establish the default setting for the
programmable memory buttons.
Once a module is initialised, the programming is retained regardless if it
is moved or a second CAPN module is connected to it.
If the CAPN module indicators have stopped flashing, unplug the module
and then reconnect it. The indicators should turn on and flash for ten
seconds.
To initialise the CAPN module:
While the CAPN indicators are flashing, simultaneously press the two
buttons on the lower left side and the lower right side of the CAPN
module.
The indicators turn on one at a time in sequence, beginning at the lower
right corner of the module. The indicators then turn off. After all the
indicators turn off, the CAPN module is initialised and ready to use.
P0908521 Issue 02
Advertisement
