Installation; Installation Conditions; Preparation For Installation; Mounting The Actuator - Samson TROVIS 5757-3 Mounting And Operating Instructions

Electric actuator with process controller for domestic hot water heating

Hide thumbs Also See for TROVIS 5757-3:

Table of Contents

5 Installation

Work position

If not described otherwise in the valve docu-

mentation, the work position for the control

valve is the front view looking onto the oper-

ating controls.

Mounting orientation

The control valve can be installed in the

pipeline in any desired position. However, a

suspended mounting position of the actuator

is not permissible (see Fig. 5-1).

The cable gland must not face upward after

installation.

0...90°

Fig. 5-1: Mounting position

EB 5757 EN

Before installation, make sure the following

conditions are met:

− The actuator is not damaged.

Proceed as follows:

Lay out the necessary material and tools to

have them ready during mounting.

The actuator is mounted directly onto the

valve (see Fig. 5-2).

1 Electric actuator with process

controller

2 Coupling nut

Fig. 5-2: Mounting

Installation

5-1

Table of Contents