Fluke CableAnalyzer DSP-4000 Series User Manual page 39

Item Feature
1
RS-232C serial port
2
2.5 mm phone jack
3
AC adapter/
charger jack
4
AC power indicator
5
LIA connector and
latch
6
Pass LED
7
Test LED
8
Fail LED
9
Talking LED
0
Low-battery LED
f X
TALK
g
Rotary switch
Table 2-5. Remote Connectors and Features
A DB9P connector for loading software updates.
Connection for the headset supplied with the test tool.
Connection for the ac adapter/charger supplied with the test
tool.
LED off,
unit turned off
LED off,
unit turned on
LED flashing
red
LED steady red
LED steady
green
Connector and latch for attaching link interface adapters.
A green LED that turns on at the end of a test if no faults were
detected.
A yellow LED that turns on when a test is in progress.
A red LED that turns on at the end of a test if one or more faults
were detected.
A LED that turns on when the Talk mode is active.
A LED that turns on when the remote battery voltage is low.
Lets you use the headset for two-way voice communication
over twisted pair or fiber cable. When the Talk mode is active,
this button controls the headset volume.
On/off switch for remote.
Description
Battery is not charging.
The charger is not plugged in.
Battery is not charging.
The charger is not plugged in or the test
tool is running a test. When the test is
finished, charging resumes unless the
battery is already charged (>80%).
Fast charge pending.
Charging is beginning. This state may last
for several minutes until fast charging
begins.
Fast charge.
The unit stays in fast charge mode for up to
4 hours, or until either the battery is fully
charged or a test is initiated.
Charge complete.
Fast charge is complete. The unit enters
trickle charge mode.
Getting Started
2
Remote Features
2-21