Controlling Your Tv Or Av Receiver (Amplifier) With The Supplied Remote - Sony DVP-S9000ES Operating Instructions Manual

Controlling Your TV or AV Receiver (Amplifier)
with the Supplied Remote
By adjusting the r emote signal, you can contr ol your TV
or AV receiver (amplifier) with the supplied r emote.
Controlling TVs with the remote
TV/DVD
switch
1 2
Number
4 5
7 8
buttons
0
1
Slide the TV/DVD switch to TV .
2
Hold down ?/ 1, and enter your TV's manufactur er's
code (see the table) using the number buttons.
Then release ?/ 1.
Code numbers of controllable TVs
If more than one code number is listed, tr
one at a time until you find the one that works with your
TV .
Manufacturer Code number
Sony (default) 01
Grundig 11
Hitachi 24
Loewe 45
Nokia 15, 16, 69
Panasonic 17, 49
Philips 06, 07, 08
Saba 12, 13
Samsung 22, 23
Sanyo 25
Sharp 29
Telefunken 36
Thomson 43
Toshiba 38
?/1 (on/standby)
button
3
6
9
y entering them
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote, the code number
may be reset to the default setting. Reset the appropriate code
number.
Controlling the TV
You can contr ol your TV using the buttons below . When
you set the TV/DVD switch to TV , you can also contr ol
the number , -/--, ?/ 1 and ENTER buttons.
TV/DVD
TV/DVD
1 2 3
switch
4 5 6
Number
7 8 9
0
buttons
-/--
By pressing
You can
?/1 Turn the TV on or off
TV/VIDEO Switch the TV's input source between
the TV and other input sources
TV/DVD* Switch the TV's input source between
the TV and SACD/DVD player
VOL
Adjust the volume of the TV
PROG Select the program position of the TV
WIDE MODE Switch to or from the wide mode of a
wide TV.
Number buttons, Select the program position of the TV
-/-- and ENTER
* If you connect the player to the TV via the SCART (EURO AV)
connectors, the input source for the TV is set to the player
automatically when you start playback or press any button
except for ?/1. In this case, press TV/DVD to return the input
to the TV.
Notes
• Depending on the TV, you may not be able to control your TV
or to use some of the buttons above.
• If you use number buttons to select the TV's program position,
press -/-- followed by the number buttons for two-digit
numbers.
?/1 (on/standby)
button
VOL
PROG
TV/VIDEO
WIDE MODE
ENTER
ENTER
67