Controlling The Tv Or The Av Receiver (Amplifier) With The Supplied Remote - Sony DVP-CX850D Operating Instructions Manual

Adjust ing t he speaker volum e
1
While you stop playback, select "SPEAKER SETUP"
after pressing SET UP .
2
Select "TEST TONE" and set "TEST TONE" to "ON."
You will hear the test tone from each speaker in
sequence.
3
From your listening position, select "BALANCE" or
"LEVEL" and adjust the value of "BALANCE" and
"LEVEL" using > / . .
During this adjustment, the test tone is emitted from
both speakers simultaneously.
4
Select "TEST TONE" and set "TEST TONE" to "OFF"
to turn off the test tone.
Downloaded from: https://www.usersmanualguide.com/
Cont rolling t he TV or t he
AV Receiver (Am plif ier)
w it h t he Supplied Rem ot e
Z
If you adjust the remote signal, you can control your TV
with the supplied remote. Default setting is to control
Sony TVs with the g mark.
When you connect the player to a Sony AV receiver
(amplifier), you can also set the input of the receiver
(amplifier) to this player with the supplied remote.
TV/ DISC EXPLORER/
DVD sw itch
1
Number buttons
4
7
A
Cont rolling TVs w it h t he rem ot e
1
Slide the TV/ DISC EXPLORER/ DVD sw itch to TV.
2 Hold dow n 1 / u (POWER), and enter your TV's
manufacturer's code (see the table on the next
page) using the number buttons. Then release 1 / u
(POWER).
Code num bers of cont rollable TVs
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
TV.
Notes
• If you enter a new code number, the code number previously
entered will be erased.
• When you replace the batteries of the remote commander, the
code number may reset to 01 (Sony). Reset the appropriate code
number.
1 / u (POW ER)
2 3
5 6
8 9
0
B C D ALL
DVD CD
67