Controlling Your Tv Or Av Amplifier (Receiver) With The Supplied Remote - Sony DVP-NS700P Operating Instructions Manual

To turn off the Sound Feedback
function
When there is no disc in the player, press and
hold X on the player for more than two
seconds. You will hear two beeps and the
Sound Feedback function is turned off.
64
Controlling Your TV or AV
Amplifier (Receiver) with
the Supplied Remote
By adjusting the remote signal, you can
control your TV or AV amplifier (receiver)
with the supplied remote. The default signal
(01) will control Sony TVs.
If you connect the player to an AV amplifier
(receiver), you can control the volume with
the supplied remote.
Notes
N
Depending on the units being connected, you may
not be able to control your TV or AV amplifier
(receiver) using some of the buttons below.
N
If you enter a new code number, the code number
previously entered will be erased.
N
When you replace the batteries of the remote, the
code number you have set may be reset to the default
setting. Set the appropriate code number again.
Controlling TVs with the remote
TV/DVD
1
Number
4
buttons
7
1
Slide the TV/DVD switch to TV.
2
Hold down [/1, and enter your TV's
manufacturer's code (see the table
below) using the number buttons.
3
Release [/1.
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your TV.
[/1
2 3
TV/VIDEO
5 6
8 9
VOL +/–
0