Sampling auto adjust
The Sampling autoadjust function offsets the progressive loss of
performance of the sampling line.
Execution of the function is requested by the user interface every 20
h of operation but can also be started manually at any time
( Sampling auto adjust command).
It is also possible not to start the procedure when requested (SKIP
key) by the HID but this procedure is initiated subsequently at each
start-up until it is executed.
The Sampling auto adjust procedure makes an indirect measurement of the
NOTE
flow sampled; therefore, in some cases, it may take several minutes.
PHD-4 Portable Helium Detector User Manual
Technical Information
/
87-900-120-01 (F )
5
User Interface
117/140