Extraordinary Maintenance - Smeg Classica C92IPBL9-1 Translation Of The Original Instructions

1. After having started the pyrolysis cycle,
press and hold the
2 seconds.
2. Continue to press the
appears on the display.
3. Press the and
5 seconds to set the time at which you
want the cleaning cycle to end.
4. Press the button to confirm the
settings.
Be careful not to turn the function
knob when setting the pyrolytic
cycle. If you do, the settings entered
via the programmer clock will be
deleted and you will have to reset
them.
During the first pyrolytic cycle,
unpleasant odours may occur due
to the normal evaporation of oily
manufacturing substances. This is
an absolutely normal phenomenon
which disappears after the first
pyrolytic cycle.
During the pyrolytic cycle the fans
produce a more intense level of
noise due to a greater rotation
speed. This is an absolutely normal
operation, intended to provide
more effective heat dispersal. At
the end of the pyrolytic cycle, the
fans will continue to operate for
long enough to avoid overheating
the walls of adjacent units and the
front of the oven.
Cleaning and maintenance
button for
button until
buttons within

4.5 Extraordinary maintenance

Installing and removing the seal
To remove the seal:
• Unhook the clips located in the 4 corners
and in the centre, then pull the seal
outwards.
To refit the seal:
• Hook the clips located in the 4 corners
and in the centre of the seal back on.
Seal maintenance tips
The seal should be soft and elastic.
• To keep the seal clean, use a non-
abrasive sponge and wash with
lukewarm water.
105