Mercedes-Benz SLK-Class 2008 Owner's Manual page 74

Belt loop
1
Belt tongue
2
Buckle
3
Release button
4
Routing the belt
Adjust the seat and move the backrest to
X
an almost vertical position (
Pull the belt smoothly through belt loop
X
1.
Route the belt over the centre of the shoul-
X
der without twisting it.
Engage belt tongue
X
If necessary, pull upwards on the shoulder
X
section of the belt to tighten the belt across
your body.
Routing the belt
Press release button
X
tongue 2
Belt warning for driver and front
passenger
The < seat belt warning lamp in the instru-
ment cluster reminds you that all occupants
should fasten their seat belts. The
belt warning lamp may light up continuously
or it may flash. Additionally, there may be a
warning tone.
The < seat belt warning lamp goes out and
the warning tone ceases when the driver and
the front passenger have fastened their seat
belt.
page 59).
For certain countries only: regardless of
Y
whether the driver or the front passenger is
already secured, the
lamp lights up for six seconds after the engine
has been started. The
2 into buckle3.
4 and guide belt
back towards belt loop 1.
< seat
< seat belt warning
< seat belt warning
lamp then goes out if both the driver and the
front passenger have fastened their seat belt.
i
Further information about the
belt warning lamp ( page 193).
Y
Correct driver's seat position
Steering wheel
1
Seat belt
2
3 Seat
Controls
Seat belts
< seat
71