Table of Contents
Advertisement
Closing the boot separator
Closing the boot separator
Pull the boot separator backwards in the
X
direction of the arrow by its handle until it
engages in the luggage compartment lip on
both sides.
Opening the boot separator
Reach into the handle of the boot separa-
X
tor.
Press the release button in the handle of
X
the boot separator.
The boot separator is unlocked.
* optional
Pull the boot separator up out of the eyelets
X
on the luggage compartment lip.
Push the boot separator forwards by the
X
handle in the opposite direction of the
arrow.
Draught stop*
The draught stop is a wind protection device
for driving with the soft top open.
Depending on the vehicle's equipment, a dif-
ferent draught stop may be provided. In this
case you should read the assembly instruc-
tions provided with the draught stop.
G Risk of accident
Dismantle the draught stop if your vision is
restricted or as soon as it is dark. It could
otherwise impair your rear view. You could
cause an accident because of this.
Opening/closing the roof
Fitting
Draught stop
1
Press-studs
2
Retainer loop
3
Securing pin
4
Gap
5
Hook retainer loops
3
to securing pins
X
4.
i
Make sure the lower edge of the draught
stop is routed through gap
5
stowage compartment and the rear wall.
Push press-studs
2
of the draught stop
X
onto the corresponding counterpieces.
Pull draught stop
1
over the roll-over bars.
X
Pull the edge, not the net, when doing so.
Controls
between the
135
Advertisement
Table of Contents
