Table of Contents
Advertisement
Version 2
TIREFIT sealant filler bottle
1
Recess
2
On/off switch
3
Electric connector with cable
4
Air pump hose
5
Flange
6
Pull connector with cable
4
X
hose
5
from the housing.
Screw air pump hose
5
onto flange
X
TIREFIT filler bottle 1.
Place TIREFIT sealant filler bottle
X
downwards into recess
2
of the electric
air pump.
* optional
Valve
7
Filler hose
8
Remove the cap from valve
X
tyre.
Screw filler hose
X
Insert plug
X
rette lighter* (
and air pump
power socket in your vehicle
(
page 141).
Y
Turn the key to position 1 (
6
of
X
the ignition lock.
1
head
7
on the faulty
8
onto valve 7.
4
into the socket of the ciga-
page 141) or into a 12V
Y
page 59) in
Y
Practical advice
Press on/off switch
3
on the electric air
X
pump to I.
The electric air pump is switched on. The
tyre is inflated.
i
First, TIREFIT is pumped into the tyre. The
pressure can briefly rise to around 5 bar.
Do not switch off the electric pump dur-
ing this phase.
Let the electric pump run for five minutes.
X
The tyre should then have a pressure of at
least 1.8 bar.
!
Do not operate the electric air pump for
longer than six minutes without a break.
Otherwise, it may overheat.
The air pump can be operated again once
it has cooled down.
If a pressure of 1.8 bar is not reached after
five minutes:
Switch off and disconnect the electric air
X
pump and drive the vehicle forwards or
backwards approximately 10 m.
This distributes the TIREFIT more evenly.
Remove TIREFIT filler bottle
X
electric pump.
Pump up the tyre again.
X
Flat tyre
1
from the
223
Advertisement
Table of Contents
