Table of Contents
Advertisement
Practical advice
Flat tyre
remove any dirt that may have collected in
the jacking points.
The jacking points for the jack are located
behind the wheel housings of the front wheels
and in front of the wheel housings of the rear
wheels.
Jacking point
1
Jack
2
Crank
3
Position jack
2
at jacking point 1.
X
226
Make sure that the base of the jack is posi-
X
tioned directly under jacking point 1.
Turn crank
3
until the tyre is raised a max-
X
imum of 3 cm from the ground.
Unscrew the uppermost wheel bolt com-
X
pletely.
Centring pin
1
In place of the wheel bolt, screw centring
X
pin
1
from the vehicle tool kit into the
thread.
Unscrew the remaining wheel bolts fully.
X
!
Do not place wheel bolts in sand or on a
dirty surface. This could cause damage to
the bolt and wheel hub threads.
Remove the wheel.
X
Fitting a new wheel
G Risk of accident
Replace damaged or corroded wheel bolts.
Never oil or grease wheel bolts.
Advertisement
Table of Contents
