Emerson Rosemount 2051HT Quick Start Manual page 17

November 2019
Procedure
1. To verify the device tag:
2. To check the switches (see
3. To disable the software write lock:
Note
Place the control loop in "Manual" mode before beginning analog
input block configuration.
3.6.3 AI block configuration
Procedure
1. To use guided setup:
2. To use manual setup:
Note
When using manual setup, perform the steps in the order described
in the
Quick Start Guide
a) Navigation: from the Overview screen, select Device
Information to verify the device tag.
a) Verify the write lock switch is in the unlocked position if the
switch has been enabled in software.
a) Navigation: from the Overview screen, select Device
Information and then select the Security and Simulation tab.
b) Perform "Write Lock Setup" to disable software write lock.
c) Place the control loop in "Manual" mode before beginning
block configuration.
a) Navigate to Configure > Guided Setup.
b) Select AI Block Unit Setup.
Note
Guided setup will automatically go through each step in the
proper order.
a) Navigate to Configure > Manual Setup > Process Variable.
b) Select AI Block Unit Setup.
c) Place the AI Block in "Out of Service" mode.
Configure the AI
Figure 3-4):
block.
Quick Start Guide
AI
17