Emerson Rosemount 2051HT Quick Start Manual page 14

Quick Start Guide
3.5.6 Signal termination
For every Fieldbus segment a terminator should be installed at the beginning
and at the end of each segment.
3.5.7 Locating devices
Devices are frequently installed, configured, and commissioned over time by
different personnel. A "Locate Device" capability uses the LCD display (when
installed) to assist personnel in finding the desired device.
From the device Overview screen, select the Locate Device button. This will
launch a method allowing the user to display a "Find me" message or enter a
custom message to display on the device LCD display. When the user exits
the "Locate Device" method, the device LCD display automatically returns to
normal operation.
Note
Some hosts do not support "Locate Device" in the DD.
3.6 Configure
Each Foundation Fieldbus host or configuration tool has a different way of
displaying and performing configurations. Some use device descriptions
(DD) or DD methods for configuration and to display data consistently
across platforms. There is no requirement that a host or configuration tool
support these features. Use the following block examples to do basic
configuration to the transmitter. For more advanced configurations, see the
Rosemount 2051
Note
™
DeltaV
blocks and Control Studio for the Function Blocks.
3.6.1 Configure the AI block
If your configuration tool supports Dashboard DD's or DTM's you may use
either guided setup or manual setup. If your configuration tools don't
support Dashboard DD's or DTM's, use manual setup. Navigation
instructions for each step are provided below. In addition the screens used
for each step are shown in
14
Reference
users should use DeltaV Explorer for the Resource and Transducer
Manual.
Device revisions and
November 2019
drivers.
Rosemount 2051HT