Remote Control Of Furuno Ssb Radiotelephone - Furuno DSC-60 Operator's Manual

2.11 Remote Control of FURUNO SSB
Radiotelephone
A FURUNO SSB radiotelephone can be controlled from the radiotelephone setting screen, which
may be displayed by pressing the [1/ RT/2182] key. You can enter desired frequency by
designating channel as below or entering Tx and Rx frequencies as on the next page. The
handset may be ON HOOK or OFF HOOK.
Note1: To set the SSB radiotelephone to 2182 kHz/J3E, press the [1/ RT/2182] key more than 2
sec.
Note2: In RT screen, "INCOMING" appears at lower left-hand side of the RT screen when the
DSC message is received.
Mode selection
1. Press the [1/ RT/2182] key to display the radiotelephone setting screen.
2. Select the MODE field with the Cursor Pad and press the [ENT] key.
3. Select mode desired and press the [ENT] key.
TELEPHONE:Telephone
NBDP/DSC: NBDP Terminal, DSC Terminal
FAX: Facsimile
MODE: TELEPHONE
MODE: TELEPHONE
CH: 12034
Tx: 12329.0
Rx: 13176.00
POWER: HIGH
TUNE
VOLUME
Channel selection
Channel cannot be selected when the MODE is FAX.
1. Select the CH field and press the [ENT] key.
MODE : TELEPHONE
- - - - -
CH:
T
- - - - - - -
x:
R
- - - - - - - - -
x:
POWER: HIGH
TUNE
VOLUME
2. Channel can be entered directly with the numeric keys, or with the cursor pad.
By numeric keys
Use the numeric keys to enter band and channel and then press the [ENT] key.
2-12
With MODE selected
press [ENT].
KHZ
KHZ
32
Select CH and
press [ENT].
KHZ
KHZ
24
MODE: TELEPHONE
MODE: TELEPHONE
TELEPHONE
CH: 12034
NBDP / DSC
Tx: 12329.0
FAX
Rx: 13176.00
POWER: HIGH
TUNE
VOLUME
MODE : TELEPHONE
CH:12O34
-----
- - - - - - -
TX:
- - - - - - - - -
RX:
POWER: HIGH
TUNE
VOLUME
KHZ
KHZ
32
-
KHZ
KHZ
24