Control Unit Furuno Rcu-018 - Furuno TECDIS Installation Manual

TECDIS Installation Manual

1.3 Control Unit Furuno RCU-018

The control unit may be mounted on a desktop, with or without the KB fixing metal
(supplied), which mounts the control unit at an angle.
Mounting considerations
When selecting a mounting location, keep in mind the following points:
• Select a location where the control unit can be operated conveniently.
• Locate the unit away from heat sources because of heat that can build up inside the cabinet.
• Locate the equipment away from places subject to water splash and rain.
• Determine the mounting location considering the length of the signal cable between the control
unit and the processor unit.
• A magnetic compass will be affected if the control unit is placed too close to the magnetic
compass. Observe the compass safe distances specified at the start of this manual to prevent
deviation of a magnetic compass.
Fixing with KB fixing plate
1. Fix the KB fixing plate to the bottom of the control unit.
2. Attach three cushions to the bottom of the control unit.
3. Fix it to a desired location with self-tapping screws (local supply).
Fixing without KB fixing metal
1. Drill four mounting holes of 5 mm diameter referring to the outline drawing.
2. Fix the control unit with four screws (M4) from under side of the desktop. (The M4
screws with a sufficient length for the thickness of the desktop should be provided
locally.)
Flush mounting
Use the optional flush mount kit Furuno FP03-09870 to mount the control unit to a console
panel.
Name: Flush mount kit
Type: Furuno FP03-09870
Code No.: 008-535-630
No. Name
1 Mount plate
2 Hex bolt
3 Wing screw
1. Prepare a cutout in the mounting location as shown in the outline figures.
2. Set the control unit to the cutout.
3. Attach the mounting plate to the control unit with four screws from the rear side.
4. Screw the wing screw to each mounting plate and then insert hex bolt to each wing screw.
5. Fasten each wing screw and then fasten the hex nuts as shown in the outline figures.
Type Qty
03-163-7531 4
M4 4
M4X30 4
Page 18