Installing The Fuser Oil Unit - Ricoh Aficio AP3800C Setup Manual

Installing the Fuser Oil Unit

Install the Fuser Oil Unit to the Fusing
Unit.
A A A A
Pull out the left cover slowly.
B B B B
Open the upper left cover.
C C C C
Holding the green handle, pull
up the Fusing Unit slowly in the
direction as shown in the illustra-
tion.
Important
❒ Do not touch any areas other
than the handle.
When replacing the fusing unit, do
not turn the blue dial at the side of
the new fusing unit until the pow-
er switch is turned on.
D D D D
Put the removed Fusing Unit in a
stable and level place.
E E E E
Take out the Fuser Oil Unit from
the bag, and remove seal (A A A A ), and
then seal (B B B B ) as shown in the il-
ZDJH047J
lustration.
ZDJH048J
Note
❒ Be sure to remove seal (A), and
then pull it out in a level man-
ner.
Important
❒ Be sure to remove the seals to
avoid printer malfunction.
❒ Be sure to remove seal (A) first,
and then remove seal (B) to
avoid an oil leak.
❒ There is oil on the removed
seals. Be careful not to let them
c om e in co n tac t w ith y ou r
clothes.
ZDJH049J
❒ Be sure to put the Fusing Oil in
a stable and level place.
Installing the Fuser Oil Unit
ZDJH053J
2
15