Table of Contents
Advertisement
Setting Up
Installing the User Account
Enhance Unit TypeB
R CAUTION:
• Do not place the IC2 lithium bat-
tery near or into fire, or it will ex-
2
plode and cause a burn.
• The User Account Enhance Unit
installed on the controller has a
IC2 lithium battery which can ex-
plode if replaced incorrectly. Re-
place the User Account Enhance
Unit only with the indicated one.
Note
❒ Disposal should take place at an
authorized dealer or an appropri-
ate collection site. An IC2 lithium
battery is inside the User Account
Enhance Unit.
❒ If you are disposing the Unit, sepa-
rate the IC2 lithium battery from
the board and dispose of them ac-
cording to local regulations.
Important
❒ Be sure to touch a metal object be-
fore touching the User Account
Enhance Unit to discharge static
electricity. Even a small amount of
static electricity can damage the
unit.
❒ Do not subject the User Account
Enhance Unit to physical shocks.
36
A A A A
Check the contents of the box.
❖ ❖ ❖ ❖ User Account Enhance Unit
❖ ❖ ❖ ❖ One Screw
B B B B
Turn off the power switch and
unplug the power cable.
C C C C
Remove two screws that are fas-
tening the Controller Board on
the back of the printer using pro-
vided screwdriver.
Reference
S e e p . 2 2 "H ow t o Us e th e
Screwdriver".
The removed screws will be used
later to fasten the Con troller
Board.
ZDJP025J
Advertisement
Table of Contents
