Table of Contents
Advertisement
Setting Up
Note
❒ Be sure to return the provided
screwdriver to its original posi-
tion on the inside of the front
cover.
This completes the installation of
the Duplex Feed Unit.
2
D D D D
Close the front cover slowly by
pressing the two points on the left
and right.
Note
❒ After finishing all installation
for printing, you can check
whether the Duplex Unit is in-
stalled properly. Print the Con-
f i g u r a t i o n P a g e f r o m t h e
"List/Test Print" menu. If it is
installed properly, you will see
"Duplex Unit" under the "Op-
tions" list.
❒ If the Duplex Unit is not in-
stalled properly, reinstall from
A
step
properly even after reinstalla-
tion, contact your sales or serv-
ice representative.
Reference
See p.69 "Test Printing".
48
. If you cannot install it
E E E E
Check for spare parts. You will
not use these spare parts.
Installing the SR770 (2 Tray
Finisher)
Preparation
Install the optional Paper Feed
Unit and optional Memory Unit or
ZDJH041J
optional Printer Hard Disk first,
and then install the 2 Tray Finisher.
If you want to use the optional
Memory Unit, 1394 Interface Unit,
User Account Enhance Unit and
Printer Hard Disk at the same
time, install these options first, and
then install the 2 Tray Finisher.
R CAUTION:
• When moving the 2 Tray Finish-
er, hold the center of both sides,
and lift slowly. Lifting it carelessly
or dropping it may cause an inju-
ry.
Note
❒ The 2 Tray Finisher weighs ap-
proximately 53 kg (116.9 lbs).
ZDJP058J
Advertisement
Table of Contents
