Toro Z Master Professional 5000 Series Setup Instructions page 5

1. Grass deflector
2. Spring
7
Installing a Battery
Diesel Machines Only
Parts needed for this procedure:
2 J-bolt
2 Wing nut
1 Hold-down clamp
Procedure
Important:
This procedure only applies to
machines that do not come with a battery
installed.
Purchase a 12V battery and install it into the machine.
The engine requires a minimum of 540 CCA.
Use the hardware included to install the new battery.
Refer to Installing the Battery in the Operator's
Manual.
Figure 8
3. End of the spring
4. Deck edge
8
Installing a Battery
Gasoline Machines Only
Parts needed for this procedure:
1 Clamp
2 Wing nut (1/4 inch)
2 Battery hold-down
g021181
Procedure
Important:
This procedure applies only to
machines that do not come with a battery
installed.
1. Purchase a 12V battery.
Models with a 29 hp engine and below require a
battery with a minimum of 260 CCA.
Models with a 30 hp engine and higher require a
battery with a minimum of 340 CCA.
2. Locate the battery-mounting hardware and
install it into the machine. Refer to Installing the
Battery in the Operator's Manual.
9
Charging the Battery
No Parts Required
Procedure
WARNING
Charging the battery produces gasses that
can explode and cause serious injury.
• Keep cigarettes, sparks and flames away
from the battery.
• Make sure the ignition switch is off.
• Ventilate when charging or using the
battery in an enclosed space.
Important:
Do not run the machine with the
battery disconnected; electrical damage may
occur to the engine.
5