Toro Z Master Professional 5000 Series Setup Instructions page 4

2
Adding Fuel to the Machine
No Parts Required
Procedure
Add fuel to the machine before starting it. Refer
to your Operator's Manual for the correct fuel and
procedure.
3
Checking the Engine-Oil
Level
No Parts Required
Procedure
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
the Operator's Manual.
4
Checking the Tire Pressure
No Parts Required
Procedure
Air pressure specification: 90 kPa (13 psi)
Note:
Check the tire pressure before starting the
machine. Refer to your Operator's Manual for the
correct tire type, correct air pressure needed, and
procedure.
5
Checking the Wheel Lug
Nut Torque
No Parts Required
Procedure
Before you start the engine and use the machine,
check the wheel lug nut torque; refer to Checking the
Wheel Lug Nuts in the Operator's Manual
6
Checking the Grass
Deflector
No Parts Required
Procedure
If there are plastic ties holding the grass deflector up,
remove them and lower the deflector into place.
WARNING
An uncovered discharge opening could allow
the machine to throw objects in the operator's
or bystander's direction and result in serious
injury or death. Also, contact with the blade
could occur.
Never operate the lawn mower unless you
install a cover plate, a mulch plate, grass
deflector or bagger.
1. Ensure that 1 end of the spring is installed
behind the deck edge before installing the bolt
as shown in Figure
2. Place the other end of the spring around the
grass deflector
Important:
The grass deflector must be free
to rotate with downward tension. Lift the
deflector up to the fully open position and
ensure that it rotates freely, without binding
into the fully down position.
4
8.
(Figure 8).